VALBERG WF 1014 B AID W180C Instructions For Use Manual page 12

B B
Utilisation de l'appareil Using the appliance
IMPORTANT
• No kinks in the hose!
• The appliance must not be connected to the mixing tap
of an un-pressurized water heater.
• Check water-tightness of connections by turning the tap
completely on.
• If the hose is too short, replaça it with a suitable length
of pressure resistant hose (1000 kPa min).
• Check the inlet hose regularly for brittleness and cracks
and replace if necessary.
• The washing machine can be connected without a non-
return valve.
Connect the drain hose
In case the drain hose is installed as shown below:
11
Unhook it only from the right clip (see arrow)
20 20 EN FR
B B
Utilisation de l'appareil Using the appliance
Connect the drain hose to the Drain or hook it over the edge of a sink by means of the «U»
12
bend. Fit the «U» bend E, if not already installed, at the end of the drain hose.
NOTE
• Ensure that there are no kinks in the drain hose.
• Secure the hose so that it cannot fall down. After wash
phase, machine will drain out hot water.
• Small hand basins are not suitable.
• To make an extension use a hose of the same type and
secure the connections with clips.
• Max. Overall drain hose length: 2.50 m.
min 70 cm
max 125 cm
21 21
E
EN FR