VALBERG WF 1014 B AID W180C Instructions For Use Manual page 23

C
Useful information
Fault code
The washer stops when the program is running. The display window shows fault code «F01»,
«F03», «F13», «F14», «F24», else fault codes from «F04»to «F98» or «Unb».
Fault Code List
Displayed on Display Window
"F01"
"F03"
"F13"
"F14"
"F24"
else fault code, "F04-F98"
"Unb"
«F01» displayed on screen
The machine is not fed with water or insufficient water. Check:
• Faucet is fully open and has enough water pressure.
• Water inlet pipe is knotted or not.
• Filtering net of water inlet pipe is blocked or not (refer to maintenance and repair).
• Water pipe is frozen or not.
Fault Description
Water inflow fault
Drainage fault
Door lock fault
Door unlock fault
Overflow or too much foam.
Electronic module fault.
Unbalance alarm
42 EN
C
Useful information
Press «Start/Pause» key after fault is removed.
If fault occurs again, please contact with after-sale service (refer to after-sale service.).
«F03» displayed on screen
The washer is not emptied. The washer stops the program being executed. Shut down the
machine and disconnect power supply. Check:
• Drain pipe is knotted or not.
• Filter in drain pump is blocked or not (refer to the cleaning of filter in drain pump)
IMPORTANT
Ensure that the water has cooled before draining the
appliance.
• The drain hose is frozen up.
Plug in the appliance again.
Select and start the «Spin « program or push the «On/off « button for at least 3 seconds and
restart the desired program.
If the fault occurs again, please contact After-Sales Service (see «After-Sales Service»).
43 EN