VALBERG WF 1014 B AID W180C Instructions For Use Manual page 10

B B
Using the appliance Utilisation de l'appareil
3 Pull out transportation bolt together with rubber part and plastic part.
4 To ensure safety and reduce noise, you should install the transportation bolt cover supplied
with the unit (see the annex accompanying the unit). Lean and place the transportation bolt
into hole and press it following the shown direction until it clicks.
IMPORTANT
Keep the transport bolts and the wrench for future
transporting of the appliance and in this case refit the
transnort bolts in reverse order.
16 16 EN FR
B B
Using the appliance Utilisation de l'appareil
Adjustment of the feet
The appliance must be installed on a solid and level floor surface (if necessry use a spirit level).
If the appliance is to be installed on a wooden floor, distribute the weight by placing it on a
60x60cm sheet of plywood at least 3cm in thickness and secure it to the floor. If the floor is
uneven, adjust the 4 leveling feet as required; do not insert pieces of wood etc. under the feet.
5 Slacken the locknut clockwise (see arrow) using the wrench.
6 Lift the machine slightly and adjust the height of the foot by revolving it.
Higher
7
IMPORTANT
Tighten the locknut by turning it anti-clockwise towards
the appliance casing.
17 17
Lower
max 20 mm
EN FR