Advertisement
Available languages
Available languages
B
B
Utilisation de l'appareil
Using the appliance
Before using the washing machine
1. Removing the packaging and inspection
• After unpacking, ensure that the washing machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales Service or your local retailer.
• Check that the accessories and supplied parts are all present.
•
Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
2. Remove the transport bolts
• The washing machine is fitted with transport bolts to avoid any possible damage to the
interior during transport. Before using the machine, it is imperative that the transport
bolts are removed.
• After their removal, cover the openings with the 4 enclosed plastic caps.
3. Install the washing machine
• Move the appliance without lifting it by the worktop.
• Install the appliance on a solid and level floor surface, preferably in a corner of the room.
• Ensure that all four feet are stable and resting on the floor and then check that the washing
machine is perfectly level (use a spirit level).
• Ensure that the ventilation openings in the base of the washing machine (if available on
your model) are not obstructed by a carpet or other material.
4. Water inlet
• Connect the water supply inlet hose in accordance with the regulations of your local water
company.
• Water inlet - Depending on models:
Single inlet - Cold water only
Dual inlet - Hot and cold water
• Water tap: 3/4 threaded hose connector
6
6
EN
FR
B
B
Utilisation de l'appareil
Using the appliance
5. Drain
• Connect the drain hose to the siphon or hook it over the edge of a sink by means of the
«U» bend supplied.
• If the washing machine is connected to an integrated drainage system, ensure that the
latter is equipped with a vent to avoid simultaneous loading and draining of water (siphoning
effect).
• Fix the drain hose securely to prevent scalding during machine drainage.
6. Electrical connection
• Electrical connections must be carried out by a qualified technician in compliance with
the manufacturer's instructions and current standard safety regulations.
• Data regarding voltage, power consumption and protection requirements is given on the
inside of the door.
•
The appliance must be connected to the mains by means of a socket with an earth connection
in accordance with current regulations. The washing machine must be earthed by law. The
manufacturer declines all liability for damage to property or injury to persons or animals
due to non-compliance with the directions given above.
• Do not use extension leads or multiple sockets. Make sure the capacity of the socket is
powerful enough to drive the machine during heating.
• Before any maintenance on the washing machine disconnect it from the mains supply.
• After installation, access to the mains plug or to disconnection from the mains supply
must be ensured at all times via a double-pole switch.
• Do not operate the washing machine if it has been damaged during transport. Inform
After-Sales Service.
• Mains cable replacement is only to be carried out by After-Sales Service.
• The appliance must only be used in the household for the prescribed uses.
Minimum housing dimensions:
Width: 615 mm
Height: 855 mm
Depth:referto programme chart
7
7
EN
FR
Advertisement
