VALBERG WF 1014 B AID W180C Instructions For Use Manual page 24

C
Useful information
If fault code «F13» is shown
Door lock is abnormal. Start program for 3 times to check whether the door is closed.
Open or close it again.
After fault is removed, press «Start/Pause» key. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code «F14» is shown
Door open fault.
Action: Press «Start/Pause» button. The washing machine will try to open the door.
The alarm will not be removed until the door is unlocked. Or, press the «On/Off» button to
restart the washing machine, and the alarm will be removed.
If fault code «F24» is shown
Water level reaches overflow level.
Remove it by pressing «Start/Pause « button and drain away water.
Select and start required program. If fault occurs again, disconnect power supply and contact
with after-sale service.
If else fault code «F04» to «F98» is shown
Electronic module fails.
Press the «On/off « button for 2 seconds to turn off the machine.
After fault is removed, press «On/off « button. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code «Unb» is shown
Unbalance alarm shall be solved by the following methods.
1. Laundry winding.
Press the «On/Off « button for 2 seconds for shutdown, open the door, shake the clothes and
put them back into the washing machine, then select the spin program to dry again.
2. Too light-weighted laundry.
Press the «On/Off « button for 2 seconds for shutdown, open the door, put in one or two towels,
and then select the spin program to dry again.
44 EN
C C
Informations pratiques Useful information
After-sales service
Before contacting After-Sales Service:
1. Try to remedy the problem yourself (see «Troubleshooting Guide»).
2. Restart the programme to check whether the problem has solved itself.
3. If the washing machine continues to function incorrectly, call After-Sales Service.
Transport/handling
Never lift the appliance by the worktop when transporting.
1. Pull out the mains plug.
2. Turn off the tap.
3. Disconnect the inlet and drain hoses.
4. Eliminate all water from the hoses and from the appliance (see «Removing the Filter»,
«Draining Residual Water»).
5. Fit the transport bolts (obligatory).
6. The machine is over 55 Kg in weight, two persons are needed to move it.
Electrical connection
Only use a socket with an earth connection.
• Do not use extension leads or multi sockets.
• Electric supply must be adequate for the machine's 10 A Current Rating.
• Electrical connections must be made in accordance with local regulations.
• The electrical power cable must be replaced exclusively by a licensed electrician.
45 45 EN FR