Attach The Rack-Mount Brackets-Chassis Rear-Mounted - Cisco ASR 1004 Quick Start Manual

To install the Cisco ASR 1004 Router in an equipment rack, see
Step 6
"Two-Post Rack Installation" section on page
Note If you install cable management brackets, make certain that the chassis is mounted in the equipment rack first.
Attach the Rack-Mount Brackets—Chassis Rear-Mounted
To install the rack-mount on a Cisco ASR 1004 Router for a rear rack-mount configuration, follow these steps:
Step 1 Locate the threaded holes in the rear sides of the chassis. Make certain that you hold the rear rack-mount bracket with
the ear facing outward and towards the rear of the chassis. Align the rack-mount bracket to the side of the router.
Position the rear rack-mount bracket top hole with the chassis second top hole in from the back (See
Step 2
Figure 2 Attaching the Rear Rack-Mount Brackets to Cisco ASR 1004 Router
Rear rack-mount bracket ear and holes
1
Rear rack-mount bracket (first bracket to attach to
2
chassis)
Insert and tighten the screws. After the bracket is secured to the side of the chassis, slide the two remaining components
Step 3
into the side rack-mount bracket.
Repeat Step 1 through Step 3 on the other side of the chassis. Use the screws on each side to secure the rear rack-mount
Step 4
brackets to the chassis.
This completes the procedure for attaching rear rack-mount brackets to the chassis. Continue on to installing the chassis in a
rack.
1
1
0
"Four-Post Rack Installation" section on page 6
8.
1
Rear rack-mount bracket components that slide into rear
3
bracket which is attached to the chassis
Rear rack-mount bracket screws
4
2
4
or
Figure 2).
3
5