Chassis Ground Connection Installation - Cisco ASR 1004 Quick Start Manual

Figure 5 Attaching the Cable-Management Bracket to the Cisco ASR 1004 Router
Cable-management bracket screws
1
2 Cable-management bracket
Using the bottom rack-mount ear hole, insert the screw through cable-management bracket and into the chassis
Step 3
rack-mount (see
Step 4 Using a Phillips screwdriver and the
bracket
Repeat steps one through four for the other side of the Cisco ASR 1004 Router.
Step 5
This completes the procedure for installing the cable-management bracket on a Cisco ASR 1004 Router for a front rack-mount
configuration.

Chassis Ground Connection Installation

Before you connect power or turn on power to your router, you must provide an adequate chassis ground (earth) connection
for the chassis ground connectors are provided on each Cisco ASR 1004 Router. The chassis ground connector is located on the
side of the Cisco ASR 1004 Router.
The following tools, equipment, and supplies necessary to connect the system ground to the chassis:
• Phillips screwdriver
• Dual-lug chassis ground component
• Grounding wire
Figure 6 shows the location of the dual ground lug on the rear of the of Cisco ASR 1004 Router.
10
1
3
2
CR IT
MA J
ACT V
PW R
MIN
STB Y
STA T
AS R1 00 0-R P1
Figure 5). Figure 4 shows the cable-management brackets attached to the chassis in a rack.
cable management screw
SPA -4XO C3- POS
POS
SPA -4XO C3-
SPA -4XO C3- POS
POS
SPA -4XO C3-
LIN K CO N
ERN ET
HD CA RR IER MGM T ETH
BIT S
US B
DF
DIS K
1
0
1
Chassis front rack-mount bracket ear
3
, thread and tighten the screw to the cable-management
SPA -4XO C3- POS
SPA -4XO C3- POS
SPA -4XO C3- POS
SPA -4XO C3- POS
AUX