Attaching The Chassis Rack-Mount Brackets - Cisco ASR 1006 Installation Manual

Cisco ASR 1006 Router Overview and Installation
The space must be at least 17.7 inches (45 cm) to accommodate the chassis which is 17.25 inches (43.8 cm) wide and
fits between the mounting posts on the rack.
Figure 7: Verifying Equipment Rack Dimensions

Attaching the Chassis Rack-Mount Brackets

This section explains how to attach the front and rear rack-mount brackets to the chassis. Before installing
the chassis in the rack, you must install the rack-mount brackets on each side of the chassis.
The parts and tools required for installing the rack-mount brackets and cable-management brackets are listed
in the
Note The cable-management brackets are installed on the chassis after you install the chassis rack-mount brackets
and mount the chassis in the rack.
Chassis Front Rack-Mount Brackets
Determine where in the rack you want the chassis to be mounted. If you are mounting more than one chassis
in the rack, then start from the bottom up or the center of the rack. The following image shows the brackets
attached to the chassis. Depending on the bracket holes you use, the chassis may protrude in the rack.
To install the front rack-mount brackets on the Cisco ASR 1006 Router, perform the following steps:
"Tools and Equipment" section on page 5-23
Attaching the Chassis Rack-Mount Brackets
.
Cisco ASR 1000 Series Router Hardware Installation Guide
11