Advertisement
How to install
Connecting to the power supply /
Only direct connection to wall switch is allowed.
Please refer to fi gure below.
Green•Yellow (Earth) /
•
Ceiling Fan /
Earth /
3
Regulator /
■
Attention:
It is recommended to user to install OFF/ON switch on the
1
wall for the Ceiling Fan, replacing existing regulator or new
regulator point.
This product should be installed with a double poles single
2
throw switch (breaker switch) with a minimum of 3 mm
contact gap in the fi xed installation circuit.
Do not use regulator or dimmer switch for this model.
3
(It can damage the Ceiling Fan)
Should there be a regulator or dimmer switch, disconnect it
4
and reconnect the wiring as above.
WARNING
Electrical wiring must be done by a qualifi ed
individual.
Can cause fi re or electrical shock.
This product is not provided with a cord and plug
or with other means for connection to the supply.
When connecting or changing the power cord
or lead wire, it must be performed by a qualifi ed
person in order to avoid a hazard.
Please use 227IEC53(RVV) or thickness of tube
1 mm or above. (If there are other requirements
such as the diameter of lead wire, please use
according to the regulation of the country).
Can cause fi re or electrical shock.
Do not bypass and short circuit the Safety
Switch.
Can cause fi re, electrical shock, injury or Ceiling Fan
to drop.
Check point after installation
The wiring is connected properly to the power supply.
4
■
Install the Blades
1
Remove the Protection Film
(for E48GP).
Blue (Neutral) /
Brown (Live) /
1
4
Dimmer switch /
Regulator /
n
from the LED Cover
1
n
2
Double poles single throw switch
(Breaker Switch) /
Wall Switch (OFF / ON) /
/
Power supply /
Connect directly /
■
:
OFF/ON
1
2
3
4
227IEC53(RVV)
■
LED
v
1
v
v
Rated voltage is mentioned on product. /
Power supply /
Connect directly /
Dimmer switch /
3
1
E48GP
n
11
Advertisement
