Reception; Handling - AERMEC WRL 200 Installation Manual

RECEPTION

RECEPTION
TRANSPORT AND HANDLING
The unit must be handled by qualified personnel. Carefully follow the
lifting instructions on the labels placed on the unit.
The unit must be lifted with extreme care to prevent knocks to the frame,
panels, electrical panel, etc..
NOTE: Plastic elements can be used to protect the units against damage
during transport. The machine is also wrapped in packaging. We recom-
mend keeping this protection during all transport and lifting operations
and not remove the plastic elements until commissioning.
If the unit has anti-vibration supports, they must be installed on the unit
before final positioning.
Inspection upon receipt
Perform the following check upon receipt of the product.
- Check that the exterior has not been damaged in any way.
- Check that the lifting and transport devices are appropriate to the
type of equipment and compliant with the transport and handling
instructions attached to this manual.
- Check that the accessories required for on-site installation have been
delivered and are operational.
- If the unit is provided pre-loaded with refrigerant, make sure there have
been no leaks.
- Check that the equipment supplied corresponds to the order and
delivery note
Product identification
The Aermec products can be identified by the packaging label bearing
the identification data of the product and by the technical plate bearing
the performance and technical data of your unit.
If the product is damaged, send a registered letter with the details of
the problem to the shipping company within 48 working hours from
delivery.
LIFTING
The units are delivered on a pallet; they must be lifted using suitable
belts. Place protections between the belts (rope or chains) and the
framework to prevent damage to the structure.
Should you desire to lift using the forklift, we recommend opening the
forks as much as possible to make handling safer
• Follow all safety regulations and standards
• Wear protective goggles and work gloves
• Pay the utmost attention to heavy and bulky equipment during lifting
and handling, and when placing it on the ground.
• All panels must be tightly fixed before moving the unit;
• Before lifting, check the specific weight on the technical plate.
• Use all, and only, the lifting points indicated;
• Use ropes in compliance with Standards and of equal length;
• Handle the unit with care and without sudden movements
• Do not stand under the unit during lifting
• The machine must be kept in a vertical position
Attention: the units cannot be stacked
8
Packaging label
Packaging label
Technical plate
DISEGNO SPECIFICO DEL MODELLO-
SOLLEVAMENTO UNITÀ CON CINGHIE,
Motor data plate
CORDE O FUNI

HANDLING

Technical plate