Precautions For Disassembly And Reassembly - Olympus UES-40 Maintenance Manual

UES-40

1. Precautions for disassembly and reassembly

(1) Keep all components safe, since you will need to reattach them at their original positions and reroute
the cables as originally routed.
(2) Exercise extreme caution to prevent possible injuries during disassembly.
Be especially careful to avoid injuring yourself on the sharp edges of metal parts.
(3) Remove the cable housing carefully. Never detach cables by pulling on them.
(4) To ensure electrical safety in accordance with the governing electrical standards, attach the following
in their original configurations when reassembling:
a) Insulators, such as insulating tubes and mylar sheets
b) Cables tied with binder to keep them from touching heat-generating and high-voltage compo-
nents
c) Cover screws with toothed washers to reduce noise radiation
(5) Always use specified components.
The product is comprised of components designed to withstand anticipated vibration, heat, and volt-
age. When replacing any component, make sure that the replacement component has the same
characteristics as the original component.
(6) Be sure to use the specified tightening torque and components of specified dimensions.
(7) Clean the components.
When reusing components, first remove any sealing tape and sealing compound, then clean them.
Note that you must clean the surfaces of any O-rings and packings that will come in contact with
components before use. Failure to do so may result in water leak against moisture or other problems.
(8) Check that all screws and nuts are properly tightened.
Failure to do so will result in water leak or other problems.
Disassembly and Reassembly Procedure 3-2 ISSUE4