Table of Contents
Advertisement
Appendix A-Remote Control Operation
Setting P2 high and low temperature times.
Repeat same steps as Setting P1.
When all settings are complete, press
Timer Programming Example (default temperatures shown)
6:00 am
P1
high temp
Set temp
74 F
Automatic Turn Down
8-Hour no Motor Movement
The valve will turn to pilot ame if there is no motor
movement for an 8-hour period.
Automatic Shut-O
Low Batteries Receiver.
in the battery holder the system shuts o the re
completely. This does not apply when the power supply
is interrupted.
On-Demand Pilot (7 Day Shut-O ).
eliminates gas energy consumption during extended
appliance inactivity. When the appliance is inactive for
an extended period of time the system automatically
extinguishes the pilot. This feature helps the consumer
realize cost bene ts by automatically eliminating
energy consumption during non-heating months and
limited use.
The programmed length of inactivity to activate the
system is speci ed by the appliance manufacturer and
cannot be altered in the eld.
to save them.
8:00 am
P1
low temp
Set temp
With low battery power
This green feature
4:00 pm
P2
high temp
40 F
Set temp
Low Battery Indication
Caution
DO NOT USE a screwdriver or other metallic
object to remove batteries from holder. This
could cause a short-circuit.
Handset:
The battery icon
tery needs to be replaced. Replace with one 9 V alkaline
battery.
Battery holder:
the valve motor turns indicate the batteries need to be
replaced in battery holder. Replace with four 1.5 V alka-
line batteries.
Handset / Receiver Match
The remote control handset and receiver are
programmed to function together. In case of a
replacement of the handset or the receiver, you will
need to reset the receiver to allow them to function
together. Contact your dealer for details.
10:00 pm
P2
low temp
74 F
Set temp
will show when the bat-
Frequent 'beeps' for 3 seconds when
6:00 am
P1
high temp
40 F
25
Advertisement
Table of Contents
