Network Menu - Hitachi CP-DW10N Operating Manual

NETWORK menu

Remember that incorrect network settings on this
projector may cause trouble on the network. Be sure
to consult with your network administrator before
connecting to an existing access point on your
network.
Select "NETWORK" from the main menu to access
the following functions.
Select an item using the ▲/▼ cursor buttons on the projector or remote control,
and press the ► cursor button on the projector or remote control, or ENTER
button on the remote control to execute the item. Then perform it according to the
following table.
See the User's Manual - Network Guide for details of NETWORK operation.
NOTE • If you are not utilizing SNTP (
Manual - Network Guide), then you must set the DATE AND TIME during the
initial installation.
• The network communication control is disabled while the projector is in
standby mode if the STANDBY MODE item of SETUP menu is set to SAVING.
Please connect the network communication to the projector after setting the
STANDBY MODE to NORMAL (
Item
SETUP
(continued on next page)
39).
Selecting this item displays the SETUP
Menu for the network.
Use the ▲/▼ buttons to select an item,
and the ► or ENTER button on the remote
control to perform the item.
Use the ▲/▼ buttons to turn DHCP on/off.
Select OFF when the network does not have
DHCP DHCP enabled.
(Dynamic Host
• When the "DHCP" setting changes to "ON", it
Configuration
takes a little time to obtain IP address from DHCP
Protocol)
server.
• Auto IP function will be assigned an IP address if
the projector could not obtain an IP address from
server even if DHCP is "ON".
Date/Time Settings of the User's
Description
ON OFF
NETWORK menu
55