Connecting The Lineage Ac-Dc Power Shelf To The Cisco Ubr10012 Router - Cisco Universal Broadband Router uBR10012 Hardware Installation Manual

Connecting the External AC-input Power Shelf to the Cisco uBR10012 Router
Open the safety cover from above the DC terminal blocks by rotating the safety cover up and off of the
Step 1
DC terminal blocks of the power shelves.
Loosen and remove the M6 nuts.
Step 2
Install the DC power cables to both the DC power terminal blocks on the power shelf using the removed
Step 3
M6 nuts, and close the safety cover.
If you are connecting two Lineage power shelves to the Cisco uBR10012 router, then connect the DC
Note
"Y" power cables only to the left DC terminals block on the two power shelves.
Attach the ferrite beads to the DC power cables pairs exiting the power shelf within 6 inches from the
Step 4
DC terminal blocks on the power shelf. See
section on page
Connect the alarm monitor cable to the power shelf, see
Step 5
Proceed to connecting the Lineage power shelf to the Cisco uBR10012 router.
Step 6
•
•
Connect the un-energized AC power cables to the power shelf.
Step 7
The AC power cables must not be connected to the wall socket until, all the DC power cables and alarm
Caution
monitor cables are connected between the power shelf and the Cisco uBR10012 router.
Connect the AC power cables to the facility wall socket to energize the power shelf.
Step 8
Caution Exercise caution while connecting the AC power cables to the an energized wall socket as the power
shelf will start supplying power to the Cisco uBR10012 router.

Connecting the Lineage AC-DC Power Shelf to the Cisco uBR10012 Router

The Lineage power shelves are used with the DC PEM modules on the Cisco uBR10012 router. Two DC
PEM modules are supported on the Cisco uBR10012 router:
•
•
The following sections explain how to connect the Lineage power shelves to the Cisco uBR10012 router:
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
3-24
3-19.
UBR-PWR-DC= module—If you are using this module, see
to the UBR-PWR-DC= Module" section on page
UBR-PWR-DC-PLUS= module—If you are using this module, see
Shelf to the UBR-PWR-DC-PLUS= Module" section on page
DC PEM module (UBR10-PWR-DC=)
DC PEM module (UBR10-PWR-DC-PLUS=)
Chapter 3
"Attaching Ferrite Beads on the Lineage Power Shelf"
Connecting the Alarm Monitor Cable, page 3-31
"Connecting the Lineage Power Shelf
3-25.
3-27.
Installing the Cisco uBR10012 Router
"Connecting the Lineage Power
OL-18259-09