Setting Up The Interface - Cisco Universal Broadband Router uBR10012 Hardware Installation Manual

Cisco systems universal broadband router hardware installation guide
Hide thumbs Also See for Universal Broadband Router Cisco uBR10012:
Table of Contents

Advertisement

Configuring the Cisco uBR10012 Router at Startup

Setting Up the Interface

After you respond to the SNMP questions, the setup script lists the interfaces. The following table lists
typical interfaces found on a Cisco uBR10012 router.
Interface
Ethernet0/0/0
FastEthernet0/0/0
GigabitEthernet3/0/0
Cable6/1/0
Cable6/1/1
Cable7/0/0
Interfaces that are not okay (NO) do not have a valid configuration.
Tip
To set up an interface on the Cisco uBR10012 router:
Enter the interface for the FastEthernet interface to achieve network connectivity.
Step 1
Enter interface name used to connect to the management network from the above interface
summary: FastEthernet0/0/0
Accept the default value for the type of connector. RJ-45 is the only connector that can be used on the
Step 2
Cisco uBR10012 router Ethernet port.
Configuring interface FastEthernet0/0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Configure both the Cisco uBR10012 router and the remote device to use the same mode.
Step 3
Operate in full-duplex mode? [no]: no
Enter the IP address to achieve network connectivity.
Step 4
Configure IP on this interface? [yes]: yes
Specify the IP address.
Step 5
IP address for this interface: 172.27.48.209
Enter the subnet mask for the IP address.
Step 6
Subnet mask for this interface [255.255.0.0]: 255.255.0.0
The system displays the information you entered as well as several default commands, such as the no
shutdown command. For example:
The following configuration command script was created:
hostname c10012
enable secret 5 $$1$uror$EFU0hKOBQXhk975qKFZlL0
enable password <xxx>
line vty 0 4
password <xxx>
no snmp-server
!
no ip routing
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
3-64
IP-Address
OK?
Method
unassigned YES
unset
unassigned NO
unset
unassigned NO
unset
unassigned NO
unset
unassigned NO
unset
unassigned NO
unset
Chapter 3
Installing the Cisco uBR10012 Router
Status
Protocol
up
up
up
up
up
up
up
up
up
up
up
up
OL-18259-09

Advertisement

Table of Contents
loading

Table of Contents