Table of Contents
Advertisement
15. Press F10 to save the new configuration.
16. Reset the print server to have the changes take effect.
NOTE:
The print server may require up to a minute
after power-up to log into a NetWare Directory Services
context because of the large number of calculations NDS
security requires.
Your print server should now be ready for use by
workstation users. You should be able to redirect printing
to your print server using a CAPTURE command.
5.3.2.2
Configuring in Remote Printer Mode
This remote printer feature is not available for our
10/100Mbps 3-port models. Make sure that you have
created the NetWare print server with Type Remote using
the PCONSOLE utility before you configure the print
server. For more detailed information about PCONSOLE,
please refer to NetWare's manual. You can set up the
NetWare print server, print queue and printer objects by
following the steps below:
1. Run the NetWare PCONSOLE program.
2. Change the current context, if necessary, using the
Change Context menu selection.
Advertisement
Table of Contents
