Table of Contents
Advertisement
6. The quick installation program will not only set up the
print server, but also create and setup all required objects
on the file server. When setup is complete, it will display
an execution command that you can run after logging into
the file server to redirect print commands to the new print
server.
capture /S=III /Q=PRINTSERVER_Q1 /nt /nff /nb /l=1
/ti=10
This command redirects the LPT1 port (/l=1) to the print
queue PRINTSERVER_Q1 on the file server named III.
No banner page will be printed (/nb); no form feed will
be added to the end of the job (/nff); and tabs will not be
expanded into spaces (/nt). If the program does not
explicitly signal end-of-job, the capture facility will wait
10 seconds (/ti=10) before assuming that the print job is
complete.
7. Reset the print server to have the changes take effect.
Before printing, you may want to verify that the setup
was complete.
Using the Print Server Status option of
the PSETUP command (as described in the following
Advertisement
Table of Contents
