Table of Contents
Advertisement
installed, use the CX command to change them before
starting the INSTALL program.
6. The quick installation program will not only set up the
print server but also create and setup all required objects
on the network. When the setup is complete, it will also
display an execution command that you can run after
logging in to the file server to redirect print commands to
the new print server.
7. Reset the print server to have the changes take effect.
NOTE:
The print server may require up to a minute
after power-up to log into a NetWare Directory Services
context because of the large number of the calculations
NDS security requires.
Advertisement
Table of Contents
