Where To Go Next - Cisco Router IOS XR Getting Started Manual

Where to Go Next

0/SM2/SP
0/SM3/SP
RP/0/RP0/CPU0:router# end
Line cards in Cisco CRS-1 routers are called modular services cards (MSCs). The show platform
Note
command output is different for Cisco CRS-1 routers and Cisco XR 12000 Series Routers.
In the following example, information is shown for a single node in a Cisco CRS-1 router:
RP/0/RP0/CPU0:router# show platform 0/1/CPU0
Node
-----------------------------------------------------------------------------
0/1/CPU0
For more information on node IDs, see the Cisco IOS XR System Management Configuration Guide,
Release 3.4.
For more information on the show platform command, see the Cisco IOS XR Interface and Hardware
Component Command Reference.
show redundancy Command
To display information about the active and standby (inactive) RPs, enter the show redundancy
command as follows:
RP/0/RP0/CPU0:router# show redundancy
Redundancy information for node 0/RP0/CPU0:
==========================================
Node 0/RP0/CPU0 is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
Reload and boot info
----------------------
RP reloaded Wed Feb 15 13:58:32 2006: 1 week, 6 days, 22 hours, 49 minutes ago
Active node booted Wed Feb 15 13:58:32 2006: 1 week, 6 days, 22 hours, 49 minuto
Standby node boot Wed Feb 15 13:59:00 2006: 1 week, 6 days, 22 hours, 49 minuteo
Standby node last went not ready Wed Mar
Standby node last went ready Wed Mar
There have been 0 switch-overs since reload
Where to Go Next
For information on configuring basic router features, see
Features."
Cisco IOS XR Getting Started Guide
2-8
Chapter 2
FC/S(SP) N/A
FC/S(SP) N/A
Type PLIM
MSC Jacket Card
1 07:40:00 2006: 5 hours, 8 minutes ago
Bringing Up the Cisco IOS XR Software on a Standalone Router
IOS XR RUN PWR,NSHUT,MON
IOS XR RUN PWR,NSHUT,MON
State Config State
IOS XR RUN PWR,NSHUT,MON
1 07:40:00 2006: 5 hours, 8 minutes ao
Chapter 4, "Configuring General Router
OL-10957-02