Cisco Router IOS XR Getting Started Manual page 73

Chapter 3 Bringing Up the Cisco IOS XR Software on a Multishelf System
DETAILED STEPS
Command or Action
Step 1
Apply power to all FCCs.
Step 2 show controllers fabric rack all detail
Example:
RP/0/RP0/CPU0:router(admin)# show controllers fabric rack
all detail
Step 3 show controllers fabric plane all detail
Example:
RP/0/RP0/CPU0:router(admin)# show controllers fabric plane
all detail
OL-10957-02
Bringing Up and Verifying FCCs
Purpose
Starts the FCCs.
Allow each FCC to fully boot.
•
Verify that "IOS XR RUN" appears on the
•
SC faceplates.
Verify that the indicator LED on the OIM
•
LED panel is green for each fabric cable
connected to Rack 0.
• Each FCC loads any required software
and configurations from the DSC,
including the rack number and
appropriate Cisco IOS XR software
packages.
Do not proceed until both SCGEs in each
•
FCC display "IOS XR RUN." This
message indicates that each SCGE has
successfully loaded the Cisco IOS XR
software.
Displays the status of all racks in the system.
In a properly operating system, the rack
•
status for all racks should be Normal, and
the server status should be Present.
Displays the status of all racks and additional
information for racks in installation mode.
Wait for the status in the Admin State and
•
Oper State columns to change to UP for
all planes.
Cisco IOS XR Getting Started Guide
3-35