Qeedji SAP10e User Manual page 26

Time to obtain a connection quality
The connection quality status is showing the file download error rate averaged on the ten last files downloading between the SAP10e device and
the SLATEs. The files can be as well:
an APPLI.CFG configuration file,
a .ppk file,
a .rpk software release file.
After a SAP10e device reboot:
the connection quality displayed is grey meaning that no connection quality is available,
one hour is required to obtain a first
one hour and half is required to obtain a
☛ When the
connection q uality
In case you are facing a red
connection quality
check that the available free space on the filesystem of the SLATE device is at least 220 K B to warranty a software release file writing or a .ppk file
writing,
check that some radio frequency obstacles do not prevent the SAP10e device to work properly with the SLATE devices.
☛ The quality connection status does not bring information on the SLATE battery level.
If the red quality status persists despite of the advices above, please contact
Unpair a SLATE
To unpair a SLATE, select a SLATE in the
Device replacement
In case you must replace a SAP10e device which was paired to several SLATEs:
on the old SAP10e device:
save the
prefs.json
unpair all the SLATEs.
on the new SAP10e device:
configure the SAP10e device by copying, with a WebDAV client the
(
http://www.<SAP10e_I P_Addr>
pair all the SLATEs, whose the list has been saved with their
if a pairing was used, you must enter the right pairing
PI N code
Change the pairing PIN code
To change the pairing
PI N code
the
appli.pictureframe.slate.*.wpan1.authentication.pincode
Restore factory preferences
After a factory preferences restoring using the
table, but:
the hostnames are replaced from index 1 to index 10 with respectively
the pairing is inactivated.
PI N code
connection quality,
Red
connection quality or a
O range
is orange or red, the batteries lifetime may decrease because of the downloading attempts.
:
SL ATEs paired to this device
file,
),
of paired SLATEs, connect to the SAP10e device Web user interface, and in the
Administration console
connection quality.
G reen
support@ qeedji.tech.
right table, and click on 
file user preference at the root of the WebDAV server
prefs.json
/ /pairing
PSN H ostname
.
PI N code
.
user interface, the SLATEs are kept in the
to
slate-01
26
button.
U npairing
.
PI N code
Maintenance > Preferences
SL ATEs paired to this device
hostname values,
slate-10
menu, edit
right