Applications - Qeedji SAP10e User Manual

1.2 Applications
The application is put by default at the factory. It allows to view the SLATE content from SLATE index 1 to SLATE index 10 and check whether
regular
each SLATEs content is synchronized with the SAP10e device content source.
Configuration
The application for SAP10e device supports configuration update:
by connecting to the
Administration console
when pushing, with a WebDAV client, a
device,
when receiving a
configure
Regular application upgrade
The R egular application can be upgraded:
by using the
Administration console
by pushing, with a WebDAV client, a new firmware file
http://<device-ip-addr>/
by receiving an
install
☛ After a firmware upgrade, the device is rebooting once.
SLATE softw are upgrade
It is possible to upgrade the software version of the SLATEs paired to the SAP10e devices:
by pushing, with a WebDAV client, a new firmware file
WebDAV directory of the SAP10e device,
by using the
Administration console
Preprogrammed fl ashing sequence
The SAP10e device has two modes:
: the
Nominal mode regular
light flashing sequence below.
: the
Recovery mode regular
Depending on these modes, the
Status green LED
Mode
behaviour
1 green flashs (2 seconds)
Nominal with a 4 seconds
periodicity
2 very short and
consecutive green flashs
R ecovery
(250 ms) with a 4,5 seconds
periodicity
3 very short and
consecutive green flashs
R ecovery
(250 ms) with a 5 seconds
periodicity
4 very short and
Nominal
consecutive green flashs
or
(250 ms) with a 5,5 seconds
recovery
periodicity
5 very short and
Nominal consecutive green flashs
(250 ms)
Mode
Nominal or recovery
Nominal or recovery
user interface,
configuration file on the
prefs.json
command from the
Qether
user interface,
, pushed with a WebDAV client,
command from the tool.
Qether
user interface.
application runs properly. When a configuration or a firmware upgrade is in progress, the light illumination follows the
application can not be executed. It is required to upgrade the firmware to return to nominal mode.
applications can fall into one of these preprogrammed flashing sequences in some specific cases.
regular
Information
The regular application is running properly.
The regular application can not be executed (it should never occur). The device Web user
interface is so not available. This sequence is displayed until a new firmware upgrade is realized
with
Qether
The software resource of the SAP10e device set at factory are not valid. It should never occur. For
further information, contact
A SAP10e device
A SAP10e device
Red LED behaviour
On (steady)
Off
http://<device-ip-addr>/.conf/
tool.
bm0032_regular-sap10e-xx.yy.zz.bin
pictureframe-slate106-setup-xx.yy.zz.rpk
tool. For further information, contact
support@
is in progress. Please wait a few seconds.
Firmware upgrade
is in progress. Please wait a few seconds.
configuration
Information
The SAP10e device is powered properly.
The SAP10e device is not powered properly.
11
WebDAV directory of the SAP10e
at the root of the device WebDAV directory
on the
http://<device-ip-addr>/.output/common/
support@ qeedji.tech.
qeedji.tech.