Table of Contents
Advertisement
b) Pair all the required SLATEs
To pair the required SLATEs to this SAP10e, you have to select them, identified by their PSN in the
SL ATEs paired to this device
In the
SL ATEs paired to this device
a check column: allows to select one or several SLATEs. Selecting a SLATE allows to access to further menus for these SLATEs.
:
from 1 to 10,
#
I ndex
: SLATE Product Serial Number,
PSN
: name of the SLATE in the WPAN network,
H ostname
: received Signal Strength Indication (in dbm),
RSSI
:
Quality
Quality of connection
: the connection quality is good. The file download success rate between this SLATE and the SAP10e device is between 75%
G reen
100% .
: the connection quality is average. The file download success rate between this SLATE and the SAP10e device is between 50%
O range
75% . The download error rate has reached a threshold that can affect the file download success rate meaning that in some case, the
APPLI.CFG file or the content may not be updated for sure within the 15 minutes interval,
: the connection quality is bad. The file download success rate between this SLATE and the SAP10e device is between 0%
Red
download error rate has reached a threshold that affects seriously the file download success rate meaning that the APPLI.CFG
configuration or the content will be not updated within the 15 minutes interval. The SLATE can not be used in this condition. It is required
to install the SLATE at another location or install a new SAP10e device closer to this SLATE.
: not yet determined (value shown in the tooltip).
G rey
In the
SL ATEs paired to this device
above
Prepare SLATE pairing
configuration.
☛ By default, after a new SLATE dropping, the SLATE configuration leads to
Select one or several SLATEs in the
Then drop them into the
SL ATEs paired to this device
☛ If you try to pair a SLATE already used in a previous installation, and which was already been paired with a pairing
dropping, you are invited to enter the appropriate pairing
right table.
right table, these values can be shown for each SLATE:
:
right table, move up or move down the SLATEs so that they match the
left table.
SL ATEs detected
right table using the right arrow button
inactivated and no pairing
Test card
(4 alphanumeric digits).
PIN C ode
22
left table, and drop them into the
SL ATEs detected
you have defined in the paragraph
I ndex
required.
PIN code
.
1
PIN code
and
and
to 50% . The
, at the device
Advertisement
Table of Contents
