Table of Contents
Advertisement
SLATEs configuration
As soon as a SLATE is paired to a SAP10e device, it inherits of the configuration file
Wake-up policy:
wake up regularly:every quarter of an hour,
active days: 5/ 7 days,
active interval: 9 .00 AM - 7 .00 PM.
So before starting any pairing procedure, check attentively the SAP10e device configuration for the SLATE.
For further information, refer to the chapter §
Pairing procedure
The SAP10e device pairing allows to associate one or several SLATEs to a SAP10e device. A SLATE can be paired to only one SAP10e device at a time.
When a new SAP10e device is trying to pair a legacy SLATE already paired to another SAP10e device, the SLATE will be paired to the new
◬
SAP10e device and unpaired automatically from the other device. To prevent from any unexpected SLATE pairing by another user, a pairing
can be used.
code
☛ The pairing PIN code is not activated by default.
The SAP10e device can detect the SLATEs after they have woken up at least one since the device booting-up. In the default factory
◬
configuration, the SLATEs are programmed to wake-up and communicate for a while on the WPAN network every 15 minutes then fall again into
mode.
Sleep
a) List the available SLATEs on the WPAN network
Connect to the SAP10e device Web user interface, and in the
☛ When there is no user action change in the SAP10e device configuration during one minute, the pairing is aborted automatically. To launch
again the pairing procedure, click again on the
Wait for 15 minutes until all your SLATEs are detected by the SAP10e device. They should appear with their PSN in the
If the SLATE does not appear in the list after 15 minutes, either they are too far from the SAP10e device or the wake-up policy configuration
◬
does not allow to wake up now. For further information, refer to the
In the
left table, these parameters values are shown:
SL ATEs detected
a check column: allows to select one or several SLATEs. Selecting a SLATE allows to drop it in the right table.
: SLATE Product Serial Number,
PSN
: name of the SLATE in the WPAN network,
H ostname
: R eceived Signal Strength Indication (in dB m)
RSSI
Maintenance >
Preferences.
Configuration > SL ATEs Pairing
button.
Activate
SL ATE106 U ser manual
20
provided by the SAP10e device.
APPL I .CFG
menu, click on the
on the
Qeedji Web
button.
Activate
left table.
SL ATEs detected
site.
PI N
Advertisement
Table of Contents
