Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner
screwdriver
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on pages 28 and 29. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part
is not in the parts bag, check to see if it has been pre-assembled.
M8 Nylon
M6 Washer
Locknut (49)–4
M6 x 16mm Tapered
Button Screw (102)–8
M8 x 25mm Button
Screw (40)–4
1.
Orient the Front Stabiliser (15) as shown. Whilst
another person lifts the front of the Frame (1),
attach the Front Stabiliser to the Frame with two
M8 x 52mm Button Screws (54) and two M8
Washers (64).
.
M8 Washer
(66)–4
(64)–2
M6 x 16mm Button
Screw (8)–4
M8 x 38mm Button
Bolt (96)–4
M4 x 12mm
M4 x 16mm
Screw (41)–4
Screw (57)–10
M6 x 22mm Button
Screw (93)–3
1
1
5
and Phillips
M4 x 20mm
Screw (101)–1
M6 x 25mm Button
Screw (99)–1
M8 x 52mm Button
Screw (54)–2
15
64
54
Advertisement
