Maserati Ghibli 2016 Owner's Manual page 147

Table of Contents

Advertisement

If the vehicle electronics sense that the
vehicle drives for more than 1 mile
(1.6 km) with either turn signal on, a
continuous sound will advise the
driver to turn the signal off.
If the indicator flashes at a fast rate,
check for a defective outside indicator
light bulb.
Seat Belt Reminder Light
When the ignition switch is in
RUN, the seat belt reminder
light will light up for a few
seconds as a bulb check.
During the bulb check, you will hear
an acoustic signal if one or both front
seat belts are unbuckled.
After the bulb check or while driving,
if a seat belt remains unbuckled, the
seat belt reminder light will illuminate
in addition to the acoustic signal and a
message will indicate which belt is
unbuckled.
WARNING!
Maserati urges you to use the seat
belts correctly fastened and adjusted
at all times. Correct use of the seat
belts can help reduce the risk of
serious injury in the event of an
accident. Do not pass seat belts over
sharp edges. They could tear. Do not
pin anything to the seat belts. This
could reduce their initial strength and
cause them to tear in the event of a
crash.
Refer to "Occupant Restraint Systems"
in section 2 for further information.
Dashboard Instruments and Controls
Start&Stop Active Indicator
This telltale indicates that the
engine has been switched off
automatically by the
Start&Stop system. When the
engine starts again, the telltale will
switch off. If the telltale during an
"AutoStop" phase starts flashing, it is
necessary to restart the engine
normally with the START/STOP device
while holding down the brake pedal.
See chapter "Normal Starting of the
Engine" in section 5 for further
information.
4
145

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents