Maserati Ghibli 2016 Owner's Manual page 135

NOTE:
You have 30 seconds in which to
initiate the next step after the setting
button has been pressed.
• Return to the vehicle and press the
®
programmed HomeLink
two seconds and then release it.
• Repeat this operation a second time.
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button a
third time for two seconds and then
release it to complete the
programming/synchronization phase.
• To program the remaining two
®
HomeLink buttons, repeat each
step for each remaining button. DO
NOT erase the channels.
Reprogramming a Single HomeLink
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the RUN
position without starting the engine.
• Press and hold the desired
®
HomeLink button.
• Without releasing the button
proceed with "Programming the
hand-held transmitters" from second
step and follow all remaining steps.
System with devices without
rolling code
button for
Programming the hand-held
transmitters
For programming garage door
openers manufactured before 1995.
• Turn the ignition device to the RUN
position without starting the engine.
• Place the hand-held transmitter 1 to
3 inches (5 to 30 cm) away from the
®
HomeLink
program.
• Simultaneously press and hold both
buttons until the warning light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
®
correctly by the HomeLink
button you wish to
®
system.
Understanding the Vehicle
NOTE:
The distance necessary between the
portable hand-held transmitter and
®
the HomeLink in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
several times. Upon every attempt,
keep the setting position for at least
15 seconds before trying again.
• Press and hold the programmed
®
HomeLink button.
If the garage door opener/device
activates, programming is complete.
To program the remaining two
®
HomeLink buttons, repeat each step
for each remaining button. Do not
erase the channels.
Reprogramming a Single HomeLink
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the RUN
position without starting the engine.
• Press and hold the desired
®
HomeLink button.
• Without releasing the button
proceed with "Programming the
hand-held transmitters" from second
step and follow all remaining steps.
3
®
133