ADC HiGain H2TU-C-388 List 1E User Manual page 28

Provisioning
Table 6. H2TU-C-388 List 1E PairGain Config Screen Options
Front-panel
System Settings
Display
Screen Options
Code
Line Power Feed PWRF
Remote Provisioning RTPV
Bipolar Violation BPVT
Transparency
See "Bipolar Violation Transparency
(BPVT) Option" on page 21.
HDSL2 BER HBER
Threshold
See "HDSL2 BER (HBER) Option"
on page 22.
DS1 BER DBER
Special Loopback SPLB
Mode
SmartJack Loopback LPBK
Minor Alarm ALM
Network Alarm NAIS
Indication Signal
H2TU-R DS1 Frame CONV
Conversion
See "H2TU-R DS1 Frame
Conversion (CONV) Option" on
page 22.
20
Selection Description
OFF Disables powering to the HDSL2 pair.
ON Keeps the HDSL2 line voltage at nominal -185 Vdc.
ENA Enables remote provisioning.
DIS Disables remote provisioning.
ENA Enables BPVs and HDSL2 CRC errors at the DS1 input to be converted into
DS1 BPVs at the DS1 output at the distant end.
This makes HiGain transparent to BPVs.
DIS Disables BPV Transparency.
1E-6 The Status LED flashes red when the Block Error Rate (BER) exceeds 10
1E-7 The Status LED flashes red when BER exceeds 10
NONE Prevents generation of a system alarm due to BER.
ENA Enables the fixed 24-hour DS1 BER threshold.
DIS Prevents the generation of a system alarm due to DS1 BER.
GNLB Configures the HiGain system to respond to the generic inband loopback
codes.
A2LB Configures the HiGain HDSL2 system to respond to the inband loopback
codes of the Teltrend addressable repeater.
A3LB Configures the HiGain HDSL2 system to respond to the inband loopback
codes of the Wescom addressable repeater.
A4LB Configures the HiGain HDSL2 system to respond to the inband loopback
codes of the Wescom Mod 1 addressable repeater.
ENA Enables the HiGain HDSL2 system to recognize all inband SmartJack loopback
commands.
DIS Configures the HiGain HDSL2 system to ignore all inband SmartJack loopback
commands.
ENA Enables the generation of the output alarm on pin H when a system alarm
condition occurs.
DIS Disables the generation of the output alarm on pin H when a system alarm
condition occurs.
CI If ALMP is set to AIS, this option specifies which pattern is sent to the network
when a remote LOS or AIS occurs.
When configured for CI, an AIS-CI pattern is sent to the network.
AIS When configured for AIS, an AIS pattern is sent to the network.
OFF No frame conversion takes place at the H2TU-R. Framing is determined by the
FRMG option settings of AUTO and UNFR.
ACON Auto detection of framing and potential frame conversion at the H2TU-R.
FCON Auto detection of framing and forced frame format conversion at the H2TU-R.
April 21, 2000
152-388-115-03, Issue 03
-6
.
-7
.
H2TU-C-388 List 1E