Summary of Contents for Sunny Health & Fitness SF-E322002
Page 1
ESSENTIAL INTERACTIVE SERIES ELLIPTICAL SF-E322002 USER MANUAL IMPORTANT! Please retain owner’s manual for maintenance and adjustment instructions. Your satisfaction is very important to us, PLEASE DO NOT RETURN UNTIL YOU HAVE CONTACTED US: support@sunnyhealthfitness.com or 1- 877 - 90SUNNY (877-907-8669).
IMPORTANT SAFETY INFORMATION We thank you for choosing our product. To ensure your safety and health, please use this equipment correctly. It is important to read this entire manual before assembling and using the equipment. Safe and effective use can only be achieved if the equipment is assembled, maintained and used properly.
ASSEMBLY INSTRUCTION We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 1: Remove 4 Carriage Bolts (No. 6), 4 Arc Washers (No. 7) and 4 Domed Nuts (No.
Page 7
We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 3: A: Remove the preassembled 2 Wave Washers (No. 63), 2 Hex Bolts (No. 25) and 2 Flat Washers (No.
Page 8
We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 4: Secure the 2 Pedals (No. 27L/R) to the 2 Pedal Support Tubes (No. 18L/R) respectively using 4 Hex Bolts (No.
Page 9
We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 5: A: Attach Armrest (No. 31) to the Handlebar Post (No. 9) in place. Secure it with 2 Spring Washers (No. 34) and 2 Hex Bolts (No.
Page 10
ADJUSTMENTS & USAGE GUIDE 1. If you find there is no difference between tension level 1 to level 8, please check the connection of the tension cable. Please see Diagram A under Step 2. 2. If the meter does not show numbers correctly, please check the batteries. If the meter does not count the speed and time, please check the connections of Upper Sensor Wire (No.
Page 11
6. If you still hear noises after you did Step 4 and Step 5, please remove the Belt Cover (No. 65L/R). Loosen the screws for the Flywheel (No. 94) about a half of a rotation. See the following diagram below. 7.
BATTERY INSTALLATION & REPLACEMENT BATTERY INSTALLATION AAA 1.5V The meter uses 2 batteries. Open the battery cover from the back of meter, then put 2 batteries into the battery compartment. Make sure the (+) and (-) ends of the batteries are in the correct position.
EXERCISE METER FUNCTION BUTTONS: MODE: Press the button to select TIME, DISTANCE, and CALORIES to preset. Press the button for selection function display value on LCD or enter after setting. Press the button and hold for 3 seconds to reset all values except odometer to zero.
Page 14
Automatically counts down from targeting value during exercise. Note: This data is a rough guide which cannot be used in medical treatment. 8. ODOMETER: Displays the total accumulated distance from 0 to 9999 M (miles). User can also press MODE button to display the odometer value. 9.