Network Address
A two-digit decimal address can be assigned to each DSU III AR.
This addressing capability makes it possible to perform remote
configuration and testing in point-to-point and multi-drop
networks. Figure 5-2 shows the menu path used to change the
network address. The factory default address setting is 0. Table 5-2
shows the AT commands used to set the network address.
1=LOCAL
3=CONFIG
2 =REMOTE ENTER
Front Panel
XX (Decimal)
61202011L1-1
1=NETWORK OPT.
2=DTE OPTIONS
3=TEST OPTIONS
ADDRESS
4=DIAL OPTIONS
5=MANUAL COMMAND
AT Command
_N=xx
DSU III AR User Manual
Chapter 5. Network Configuration
1=LOOP RATE
2=NETWORK ADDR
3=REMOTE CONFIG
4=NETWORK TYPE
5=CLOCK SOURCE
Figure 5-2. Setting the Network Address
Table 5-2. Network Address Command
Description
Assigns a 2-digit Network Address
ENTER NETWORK
ADDRESS: 0
5-3