Chapter 4. Configuration Overview; Local And Remote Configuration - ADTRAN DSU III AR User Manual

Configuration Overview
Chapter 4

LOCAL AND REMOTE CONFIGURATION

The DSU III AR can be configured locally using the front panel or
remotely by establishing communications with another DSU. The
front panel of the local DSU can then be used to configure the
remote DSU. During remote configuration, the DSU III AR prompts
for the remote address before continuing to the C
(CONFIG) menus.
The C
relating to a specific interface or function of the DSU III AR that
requires setup.
1=Network Opt.
2=DTE Options
3=Test Options
4=Dial Options
5=Manual Command
The DSU III AR contains four different user profiles (sets of
configurations options) that are stored in read-only memory (see
Appendix C, Default Configuration Profiles on page C-1). The unit is
shipped from the factory with profile number 1 (default
configuration) loaded into the current (nonvolatile configuration)
memory. If profile 1 matches requirements for the system, then no
61202011L1-1
menu consists of a group of five submenus
ONFIGURATION
Network Interface Parameters
DTE Interface Parameters
Unit Test Options
Unit Dialing Options
ADTRAN Specific Commands
DSU III AR User Manual
ONFIGURATION
4-1