ETEKCITY TENS Unit User Manual page 20

5.
Optionally, press
10-minute increments for up to 60 minutes . The
time will show on the screen. The default time is
20 minutes.
6.
Press or
again to increase the intensity.
Note:
• Intensity can be adjusted independently for
A and B channels.
• Press / repeatedly on the left side and
right side to raise or lower intensity for
channel A (A1 and A2 output) and channel B
(B1 and B2 output).
• Lowering both intensities to 0 will reset the
timer.
Caution:
• Do not remove electrode pads by pulling on
the wire. Peel gently from any corner.
20
to increase the time by
to begin the treatment. Press
• Do not place electrodes on the carotid
artery, throat, backbone, or spine.
• If you feel pain, dizziness, discomfort, or
nausea while using the TENS unit, stop
using immediately and call your physician
or medical practitioner. Do not exceed your
comfort level.
7.
Press to pause the treatment at any time.
Press again to resume.
Note: If the TENS unit is inactive for 3 minutes, it
will turn off automatically.
8. Press and hold for 2 seconds to turn off the
TENS unit at any time.
9.
Unplug the electrodes from the TENS unit. Then
peel the pads off the skin gently and replace on
the plastic film. Never remove pads from skin
before turning off the TENS unit.