Treatment - ETEKCITY TENS Unit User Manual

Treatment

1.
Connect the lead pins to the connectors on the
electrodes. Then, place the electrodes on your
skin (with the TENS unit turned OFF). Each wire
has 2 leads with pin-inserted connectors. Make
sure the metal on the pins is not exposed.
Note: This TENS unit has 4 independent channels
(A1, A2, B1, B2). Make sure you know which
channel(s) you want to use before you connect
wires to the TENS unit.
2. Insert the lead wire plugs into the sockets on the
TENS unit. You can use up to 4.
3. Press to turn on the TENS unit. Wait 2
seconds for the TENS unit to fully turn on.
4. Select 1 of 15 therapy modes. The selected
icon will flash on the screen and show the
corresponding number.
Figure 1.1
19