Alarm Mode - DAKOTA ULTRASONICS DX-2 Operation Manual

The Alarm Mode feature of the DX-2 allows the user to set an audible
and visual parameter when taking measurements. If the measurement falls
below a nominal value, set by the user, a red light will be illuminated on the
front panel of the gauge and the beeper sounded. This improves the speed
and efficiency of the inspection process by eliminating constant viewing of
the actual reading displayed. The following pages outline how to enable
and set up this feature:
1) While the unit is off, press and hold down the ALRM key.
2) Press ON/OFF key to power up the unit.
3) Release the ALRM key - BEEP ON or BEEP OFF will be displayed
enabling or disabling the beeper.
4) Repeat steps 1 through 3 to toggle between BEEP ON or BEEP
OFF.

Alarm Mode

Using the Beeper
DX-2 Ultrasonic Micrometer
19