Installation; Unpacking; Location - Hatco HWB-11QT Installation & Operating Manual

UNPACKING

Built-In Heated Well units are shipped from the
factory with most components assembled and ready
for use.
All Built-In Heated Wells require the control panel be
remote mounted.
NOTE: Drain models ("D" in the model designation)
require installation of the drain assembly after the
unit is installed into the countertop.
1. Remove unit from box.
2. Remove information packet. To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card.
3. Remove tape and protective packaging from all
surfaces of unit.

LOCATION

NOTE: A qualified electrician is recommended for
connecting the Built-In Heated Well units to a power
source. A qualified plumber is recommended for
connecting drain.
WARNING
To avoid personal injury or damage to
equipment, the Built-In Heated Wells must be
installed by qualified,
Installation must conform to all local electrical
and plumbing codes. Check with your local
plumbing and electrical inspectors for proper
procedures and codes.
WARNING
Risk of fire, install Built-In Heated Well a
minimum of 3-1/2" (89 mm) from bottom of
appliance to all combustible surfaces to assure
safe and proper operation.
WARNING
To assure safe and proper operation the remote
control panel with thermostat control must have
at least a 6" (152 mm) clearance from the Built-
In Heated Well.
trained installers.
To avoid any injury or damage locate the unit
at the proper counter height, in an area that
is convenient for use. The location should be
level and strong enough to support the weight of
the unit and food product.
To avoid injury or damage to the unit DO NOT
clean the unit while it contains any food product.
Remove food product and allow unit to cool
completely before cleaning.
Do not locate the Built-In Heated Well in an area
subject to excessive temperatures or grease
from grills, fryers, etc. Excessive temperatures
could cause damage to the unit.
Damage to countertop material such as Corian
and similar products caused by heat generated
from Hatco equipment is not covered under the
Hatco warranty. Contact the manufacturer of the
base material for application information.
11

INSTALLATION

CAUTION
CAUTION
CAUTION
CAUTION
Form No. HWBM-0107
®