Setting The Desired Value; Control Behaviour - Heidolph EKT 3001 Instruction Manual

3.3.

Setting the Desired Value

If neither the SET key nor the
return automatically to actual temperature display.
Heating control is switched off while the desired temperature is being set (symbol "S"),
3.4.

Control Behaviour

To prevent as much as possible, any overshooting of the temperature when heating a
quantity of liquid, the EKT 3001 uses FUZZY logic for control optimization. The magnetic
stirrer's heating is switched off before the desired temperature is reached so that the liquid
is then heated only with the residual heat in the hotplate.
To heat small quantities (< 500 ml): Set the temperature of the heating
plate to approx. double the value of the desired temperature. The maxi-
mum temperature is to be used for large quantities only.
Desired values of over 150°C may be accompanied by a slight control deviation. This can
be compensated by setting a higher desired value.
press approx. 1 s
The display shows a preset value which you can change.
An "S" (symbol for desired value) appears in the fourth position
from the right.
press briefly
The desired value of your choice can be set with the arrow
keys.
press and hold
Fast change mode: After 3 seconds the desired value is
changed in increments of 10.
press
The desired value is adopted; the actual value then returns to
the display.
▲ ▼
or key is pressed within 15 seconds, the appliance will
23
E