Important Safety Information - Hatco FLAV-R-SAVOR LFST-48 Installation And Operating Manual

IMPORTANT! Read the following important safety information to avoid personal injury or
death, and to avoid damage to the equipment or property.
WARNINGS
To assure safe and proper operation, plug
unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine the proper voltage and size and
install the proper electrical outlet.
For safe and proper operation, the unit must
be located a minimum of 1" (25.4 mm) from
combustible walls and materials. If safe
distances are not maintained, discoloration
or combustion could occur.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
To prevent any injury or damage to the unit
do not pull unit by power cord.
To prevent any injury, discontinue use if
power cord is frayed or worn.
To avoid any injury, turn the power switch
OFF, unplug the unit from the power source
and allow to cool completely before
performing any maintenance or cleaning.
To avoid electrical shock or personal injury,
do not steam clean or use excessive water
on the unit.
To avoid electrical shock or personal injury,
DO NOT submerge in water. Unit is not
waterproof. Do not operate if it has been
submerged in water.

IMPORTANT SAFETY INFORMATION

Only light bulbs which meet or exceed NSF
standards, specifically designed for food
holding areas must be used. Breakage of
light bulbs not specially coated or covered
could result in personal injury and/or food
contamination.
If service is required on this unit, contact
your Authorized Hatco Service Agent, or
contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-
2966 or International fax 414-671-3976.
This product has no "user" serviceable
parts. To avoid damage to the unit or injury
to personnel, use only Authorized Hatco
Service Agents and Genuine Hatco Parts
when service is required.
Genuine Hatco Replacement Parts are
specified
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment.
It is essential to use Hatco Replacement
Parts when repairing Hatco equipment.
Failure to use Hatco Replacement Parts may
subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
1
WARNINGS
to operate safely
Form No. LFSTM-0807
in the