Important Safety Information - Hatco DL-400 Installation And Operating Manual

IMPORTANT! Read the following important safety information to avoid personal injury or
death, and to avoid damage to the equipment or property.
WARNINGS
To avoid any injury or damage to the unit(s)
connect to a properly grounded electrical
supply. Contact a qualified electrician to
determine the proper voltage, wire size and
installation method.
Decorative Heat Lamps are not waterproof.
To avoid electrical shock or personal injury
DO NOT submerge in water. Do not operate if
it has been submerged in water.
To avoid electrical shock or personal injury,
do not steam clean or use excessive water on
the unit.
To avoid any injury or damage to the
Decorative Heat Lamps turn the power OFF at
the disconnect switch/circuit breaker and
allow to cool before
maintenance.
To avoid any injury, turn the power supply
OFF to the mounting location before
installing.
For safe and proper operation locate the heat
lamp at the proper height in an area that is
convenient for use.
Decorative Heat
minimum of 1" (25 mm) clearance along the
sides of combustible walls and materials. If
safe distances
discoloration or combustion could occur.
DL standard watt heat lamps (250 watt bulb)
must have a minimum of 16" (406 mm) above
a combustible surface or minimum clearance
of 5" (127 mm) above a non-combustible
surface. If safe distances are not maintained,
discoloration or combustion could occur.
DLH high watt heat lamps (375 watt bulb)
must have a minimum of 27" (686 mm) above
a combustible surface or minimum clearance
of 5" (127 mm) above a non-combustible
surface. If safe distances are not maintained,
discoloration or combustion could occur.

IMPORTANT SAFETY INFORMATION

performing any
Lamps must have
are not maintained,
For safe and proper operation, do not install
a 375 watt bulb into a DL standard watt lamp.
To avoid any injury or damage the Decorative
Heat Lamps must only be serviced by
qualified personnel.
If service is required on this unit, contact
your Authorized Hatco Service Agent, or
contact the Hatco Service Department at 800-
558-0607 or 414-671-6350; fax 800-690-2966
or International fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury
to personnel, use only Authorized Hatco
Service Agents
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are
specified
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
a
electrical voltage, resulting in electrical
shock or burn.
1
and Genuine
to operate safely
Form No. DHLM-1207
Hatco
in the