Important Safety Information - Hatco GLO-RAY GRAIH Series Important Safety Information

Read the following important safety information before using this equipment to avoid serious injury or death and
to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAzARD:
• Units supplied without an electrical cord and plug
require a hardwired connection to the on-site electrical
system. Connection must be properly grounded and of
the correct voltage, size, and configuration for the
electrical specifications of the unit. Contact a qualified
electrician to determine and install the proper electrical
connection.
• Turn power OFF at fused disconnect switch/circuit
breaker and allow unit to cool before performing any
maintenance, adjustments, or cleaning.
• For hardwired units, all electrical connections must be
in accordance with local electrical codes and any other
applicable codes. Connections should be made by a
qualified, licensed electrician.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F).
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts may subject operators of the
equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement
Parts are specified
environments in which
aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely
in Hatco equipment.
FIRE HAzARD:
• Do not install unit above or around combustible
surfaces. Discoloration or combustion could occur.
Unit must be installed
surroundings only.
• Do not store or use gasoline or other flammable vapors
or liquids in the vicinity of this or any other appliance.
Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
414-671-6350 or International fax 414-671-3976.
Form No. GRAIHCEM1-0111
to operate safely in
they are used. Some
in non-combustible

IMPORTANT SAFETY INFORMATION

This unit is not intended for use by children or persons
with reduced physical, sensory, or mental capabilities.
Ensure proper supervision of children and keep them away
from the unit.
Make sure all operators have been instructed on the safe
and proper use of the unit.
Make sure food product has been heated to the proper
food-safe temperature before placing in unit. Failure to
heat food product properly may result in serious health
risks. This unit is for holding pre-heated food product only.
For installation with chains, make sure the chains have
sufficient strength and are securely fastened to both the
strip heater and the mounting location. Poorly installed
chains may cause the heater to loosen and fall. Do not
place anything on top of heaters installed with chains.
BURN HAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Light-equipped strip heaters that require a circuit breaker
20 amps or larger must be installed with a remote control
enclosure containing a fuse rated at 20 amps or less for
the light circuit.
Ensure safe and proper operation. Refer to the "Minimum
Clearance Requirements" listed in the Installation section
of this manual.
the
Damage to countertop material such as Corian
products caused by heat generated from Hatco equipment
is not covered under the Hatco warranty. Contact the
manufacturer of the countertop material for application
information.
Remote mounted control boxes must be installed outside
strip heater heat zone to prevent premature failure of
components due to excessive heat.
Installation of two or more separate units with less than
76 mm (3") between housings may result in premature
failure of component parts. Failure to provide proper
spacing may result in heat damage to electrical
components and are not covered by warranty.
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
3
WARNING
CAUTION
NOTICE
and similar
®