Table of Contents
Advertisement
GR, GRH, GRA, GRAH, GRAL,
GRAHL, GRN & GRNH Series
GL O-R AY
ON
rme r
Foo dwa
WI U.S. A.
AUK EE,
O
OFF
COR P. MILW
HAT CO
This manual contains important safety information
concerning the maintenance, use and operation of this
product. Failure to follow the instructions contained in this
manual may result in serious injury. If you're unable to
understand the contents of this manual, please bring it to
the attention of your supervisor. Do not operate this
equipment unless you have read and understood the
contents of this manual.
GLO-RAY
Infrared Strip Heaters
Installation &
Operating Manual
I&W #07.05.183.00
PARTS &
SERVICE
800-5 58-06
07
ASSISTA
NCE
P.COM
WWW.HA
TCOCOR
N - HO T
CA UT IO
ON
GLO -RAY
PARTS &
SERVICE
-0607
Foodw armer
ASSISTANCE
800-558
ORP.COM
WWW.HATCOC
N - HOT
CAU TIO
UKEE, WI
U.S.A.
OFF
O
CORP. MILWA
HATCO
®
GL O-R AY
07
ON
PARTS &
SERVICE
800-5 58-06
rme r
Foo dwa
ASSISTA
NCE
TCOCOR
P.COM
WWW.HA
N - HO T
CA UT IO
WI U.S. A.
O
AUK EE,
OFF
COR P. MILW
HAT CO
Este manual contiene importante información sobre
seguridad concerniente al mantenimiento, uso y
operación de este producto. Cualquier falla en el
seguimiento de las instrucciones contenidas en este
manual puede resultar en un serio daño. Si usted no
puede entender el contenido de este manual por
favor pregunte a su supervisor. No opere este
equipo al menos que haya leído y comprendido el
contenido de este manual.
Advertisement
Table of Contents
Related Manuals for Hatco GLO-RAY GR
Summary of Contents for Hatco GLO-RAY GR
-
Page 1: Operating Manual
CAU TIO UKEE, WI U.S.A. CORP. MILWA HATCO This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you’re unable to understand the contents of this manual, please bring it to the attention of your supervisor. -
Page 2: Table Of Contents
Strip Heaters. We recommend all installation, operating and safety instructions appearing in this manual be read prior to installation or operation of your Hatco Strip Heaters. Safety instructions that appear in this manual after a warning symbol CAUTION printed in bold face are very important. -
Page 3: Important Safety Information
Units equipped with a cord and plug supplied by Hatco must be plugged into a properly grounded electrical outlet of the correct voltage, size and plug configuration. If the... -
Page 4: Model Designations
Heat damage to countertop material such as ® Corian and similar products (other than stainless steel) is not covered under the Hatco warranty. Contact the manufacturer of the base material for temperature limits and application information before installing the unit. GR A H L-24 D Figure 1. -
Page 5: Model Descriptions
Hatco Glo-Ray ® Infrared Strip Heater keep hot foods at optimum serving temperatures longer. Foods do not dry out or become discolored; even the most delicate dishes hold that “just-prepared” look. The Glo-Ray pre-focused heat pattern directs heat from a tubular element to bathe the entire holding surface. -
Page 6: Specifications
SPECIFICATIONS GR MODELS-ELECTRICAL RATING CHART Model GR-18 Watts: 250 Shipping Weight: 7 lbs. (3 kg) Voltage Amps Model GR-24 Watts: 350 Shipping Weight: 7 lbs. (3 kg) Voltage Amps Model GR-36 Watts: 575 Shipping Weight: 10 lbs. (5 kg) Voltage Amps Model GR-48 Watts: 800... - Page 7 GRA MODELS-ELECTRICAL RATING CHART Model GRA-18 Watts: 250 Shipping Weight: 6 lbs. (3 kg) Voltage Amps Model GRA-24 Watts: 350 Shipping Weight: 7 lbs. (3 kg) Voltage Amps Model GRA-30 Watts: 450 Shipping Weight: 8 lbs. (4 kg) Voltage Amps Model GRA-36 Watts: 575 Shipping Weight: 9 lbs.
- Page 8 SPECIFICATIONS GRAL MODELS-ELECTRICAL RATING CHART Model GRAL-18 Watts: 370 Shipping Weight: 9 lbs. (4 kg) Voltage 120/208 120/240 100/200 Amps Model GRAL-24 Watts: 470 Shipping Weight: 10 lbs. (5 kg) Voltage 120/208 120/240 100/200 Amps Model GRAL-30 Watts: 570 Shipping Weight: 11 lbs. (5 kg) Voltage 120/208 120/240...
- Page 9 GRA-XXD MODELS- ELECTRICAL RATING CHART Model GRA-18D Watts: 500 Shipping Weight: 14 lbs. (6 kg) Voltage Amps Model GRA-24D Watts: 700 Shipping Weight: 16 lbs. (7 kg) Voltage Amps Model GRA-30D Watts: 900 Shipping Weight: 18 lbs. (8 kg) Voltage Amps Model GRA-36D Watts: 1150...
- Page 10 SPECIFICATIONS GRAL-XXD MODELS- ELECTRICAL RATING CHART Model GRAL-18D Watts: 620 Shipping Weight: 14 lbs. (6 kg) Voltage 120/208 120/240 100/200 Amps Model GRAL-24D Watts: 820 Shipping Weight: 16 lbs. (7 kg) Voltage 120/208 120/240 100/200 Amps Model GRAL-30D Watts: 1020 Shipping Weight: 19 lbs.
- Page 11 GRN MODELS-ELECTRICAL RATING CHART Model GRN-18 Watts: 250 Shipping Weight: 6 lbs. (3 kg) Voltage Amps Model GRN-24 Watts: 350 Shipping Weight: 7 lbs. (3 kg) Voltage Amps Model GRN-30 Watts: 450 Shipping Weight: 8 lbs. (4 kg) Voltage Amps Model GRN-36 Watts: 575 Shipping Weight: 9 lbs.
-
Page 12: Dimensions
SPECIFICATIONS DIMENSIONS Width Depth Models GR & 24" - 96" 6" (610 - 2438 mm) (152 mm) (584 mm) GRA & 18" - 144" 6" GRAH (457 - 3658 mm) (152 mm) (584 mm) NOTE: Units shown with optional 9-3/8" (187 mm) breath protectors and mounting flanges. -
Page 13: Installation
Heat damage to countertop material such as ® Corian and similar products (other than stainless steel) is not covered under the Hatco warranty. Contact the manufacturer of the base material for temperature limits and application information before installing the unit. - Page 14 INSTALLATION Under Shelf Mounting When mounting unit under a shelf, use adjustable angle brackets to assure proper spacing. Remote control enclosures are recommended to keep switches out of the heat zone. CAUTION To assure safe and proper operation refer to Installation Clearance Requirements listed in this manual.
-
Page 15: Assembly
ASSEMBLY Glo-Ray ® Strip Heaters are shipped with most components pre-assembled. available with a required 3" (76 mm) or 6" (152 mm) spacer pre-assembled at the factory. Optional breath protectors, mounting equipment and remote control enclosures must be installed on location. -
Page 16: Permanent Surface Mount
INSTALLATION PERMANENT SURFACE MOUNT Tubular Stand Mounting Tubular stand mounting permanently attaches the unit to a countertop or serving table. All wiring may be concealed within the tubular stand. Tubular stands are available in non-adjustable heights from 10"-16" (254-406 mm) or in adjustable heights from 10"-14"... -
Page 17: Undershelf Mounting
5. Fasten angle bracket to the underside of the shelf using appropriate fasteners. (Not supplied by Hatco.) Hanger Tab Mounting The standard mounting tabs supplied with the unit can be bent 90° for mounting the unit underneath a shelf without a rolled or flanged edge. - Page 18 INSTALLATION Clearance Requirements Surroundings Models GRA & 10" 3" GRAL (254 mm) (76 mm) GRAH & 13-1/2" 3" GRAHL (343 mm) (76 mm) NOTE: Dual Strip Heaters are not to be installed in combustible surroundings. Clearance Requirements for Non-Combustible Surroundings Corded Units with Built-In Switches (B) †...
-
Page 19: Ceiling Mounting
Do not place anything on top of warmers supported by chains. Chain supplied by Hatco is constructed of sufficient strength to securely hold the weight of the unit only when properly mounted. -
Page 20: Electrical Wiring Hook-Up
• 72" (1829 mm) or less in length • Portable mounting using C-Legs or T-Legs supplied by Hatco or Stationary mounting using “S” hooks and mounting chain supplied by Hatco. WARNING Units equipped with a cord and plug supplied by... -
Page 21: Operation
Remote Mounted Control Box (RMB) Hatco Remote Mounted Control Boxes include switches, wire leads and/or indicator lights and are ready for installation. Proper use of RMB’s require one RMB per strip heater. NOTICE To prevent premature failure to components the Remote Control Box (RMB) must be installed outside the foodwarmer heat zone. -
Page 22: Maintenance
For 120, 120/208, 120/240 applications, use Hatco part number 02.30.043.00. For 200, 220, 230 and 240 Volt units use Hatco part number 02.30.058.00. WARNING Only light bulbs which meet or exceed NSF standards, specially designed for food holding areas may be used. -
Page 23: Accessories
REMOTE CONTROL ENCLOSURES Hatco Remote Control Enclosures are available in various sizes and configurations for use with the Strip Heaters. All models are built in accordance with U.L. standards to accommodate switches, indicator lights and wiring. Consult the factory for type and location of switches for enclosure. -
Page 24: Troubleshooting Guide
TROUBLESHOOTING GUIDE WARNING To avoid any injury or damage the strip heater must only be serviced by qualified personnel. SYMPTOM Unit is turned “ON” but there is no heat. Heat is inadequate. Form No. GRM-0707 To avoid any injury or damage to the strip heater turn switch/circuit breaker and allow to cool before performing any maintenance. - Page 25 Unit mounted too close to target area. Voltage supply too high. Switches are mounted in the heat zone. Switches used are not Hatco supplied. CORRECTIVE ACTION Check to see that installation is within specifications for type/model. Increase mounting height if too close.
-
Page 26: Hatco Limited Warranty
Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer’s sole expense. - Page 27 NOTES Form No. GRM-0707...
-
Page 28: Authorized Parts Distributors
Flanders GCS Service Indianapolis 317-545-9655 P.O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. Parts & Service Fax (800) 690-2966 Printed in U.S.A. July 2007 HATCO AUTHORIZED PARTS DISTRIBUTORS NEW YORK Acme American Repairs, Inc. 319-323-1823 Brooklyn Alpro Service Co. 515-262-9308 Brooklyn...