Table of Contents
Advertisement
P9415-R-EVK Evaluation Kit
5.1.2.
J5 Test Connector Pin Descriptions
Pin
Name
Number
1
INHIBIT
2
LDO1P8
3
GP6
4
PGOOD
5
VRECT
6
VDONGLE
6. Hardware Connections–Renesas USB-I2C Dongle to Window
GUI
The P9415-R firmware provides great flexibility to customize operating parameters for custom applications.
Default values of the P9415-R operating parameters such as output voltage, FOD parameters, and current limit
are set in the firmware programmed into the internal multi-time programmable (MTP) memory. Based on the end
application, the P9415-R operating parameters can be configured by either writing to internal SRAM registers or
program parameter permanently to internal MTP memory via the I2C interface.
Connect the USB-Bridge dongle to PC via USB connector. Attach the Bridge to the I2C terminal J1 dongle on
the P9415-R EVK DEMO board as shown on Figure 8. The dongle should only be plugged-in in one direction,
extending away from the P9415-R EVK PCB, and dongle cable black line (ground) should be connected in J1
Pin3 GND.
Figure 7. USB to I2C Dongle Header of "USB-FTDI-V2-1" (FTDI) Dongle
R16UH0015EU0100 Rev.1.0
May 27, 2021
Table 2. J5 Test Connector Pin Descriptions
Type
Input
Software Enable Pin, active High.
Power
Internal power regulator 1.8V.
Input
EPP disable, High = EPP disable, Low = EPP enable.
Output
Power Good indication output.
Power
VRECT power supply from USB dongle (optional).
Power
Dongle power supply from USB dongle (optional).
Description
Blank
SCL
SDA
GND
Page 9
Advertisement
Table of Contents
