Cisco MGX-FRSM-2CT3 Configuration Manual page 30

Configuring Frame Relay Service
Step 6
6-30 Cisco MGX 8850 Installation and Configuration, Release 1.1.00, Part Number 78-6186-02
•
lmi_sig specifies the LMI signaling. 1=Other, 2=None, 3=StrataLMI, 4=AnnexAUNI,
5=AnnexDUNI, 6=AnnexANNI, 7=AnnexDNNI LMI signalling, N=none,
S=StrataLMI, and au=AnnexAUNI.
•
asyn enables asynchronous updates: (y)es or (n)o
•
elmi enables Enhanced LMI: (N or n) disable (Y or y) enable
•
T391 sets the T391 timer. The range is 5–30 seconds. It sets the interval in seconds for
NNI status polling. The default is 10.
•
T392 sets the T392 timer. The range is 5–30 seconds. It sets the interval in seconds for
UNI status polling. The default is 15.
•
N391 sets the N391 counter–the number of UNI/NNI polling cycles. The range is
1–255. The default is 6.
•
N392 sets the N392 counter–the threshold for UNI/NNI errors. The range is 1–10. The
default is 3.
•
N393 sets the N393 counter–the UNI/NNI threshold for monitored events. The range
is 1–10 and must be greater than the value of N392. The default is 4.
Configure resources for the port as needed by executing cnfportrscprtn. To see the
partitioning, use dspportrscprtn. The description has a high and low-bandwidth version:
cnfportrscprtn <port_num> <controller> <percent BW> <low DLCI> <high DLCI>
<max LCN>
For FRSM-VHS cards:
•
port_num is the port number in the range 1–2 for MGX-FRSM-2T3E3 and
MGX-FRSM-HS2 or 1–256 for MGX-FRSM-2CT3.
•
controller is a number representing the controller: 1=PAR, 2=PNNI, and 3=Tag.
•
percent BW is the percentage of the bandwidth in the range 0–100 and applies to both
egress and ingress.
•
low DLCI is in the range 0–1023.
•
high DLCI is in the range 0–1023.
•
max LCN is the maximum number of logical connections available to the controller
on this port. The ranges are 1–4000 for MGX-FRSM-2CT3 and 1–2000 for
MGX-FRSM-2T3E3 and MGX-FRSM-HS2.
For AX-FRSM-8T1 or AX-FRSM-8E1:
•
port_num is the logical port number in the range 1–192 for T1 or 1–248 for E1.
•
controller-name is PAR, PNNI, or TAG.
•
percent BW is the percentage of the bandwidth in the range 0–100 and applies to both
egress and ingress.
•
low DLCI is in the range 0–1023.
•
high DLCI is in the range 0–1023.
•
max LCN is the maximum number of logical connections available to the controller
on this port. The range is 1–1000.