Cisco MGX-FRSM-2CT3 Configuration Manual page 29

•
line_num is the DS1 number in the range 1–56 to which you assign the DS0 when both
lines are active. If you activate only one line, the range is 1–28. You can assign up to
24 contiguous DS0s to one DS1. Each physical line supports up to 28 DS1s. The
number of DS0s cannot span more than DS1.
•
ds0_speed is a number representing the DS0 speed: 1 for 56 Kbps or
2 for 64 Kbps.
•
begin_slot is the beginning DS0 timeslot in 1 base. For example, on port number 50,
you could make begin_slot=9 then specify num_slot to be in the range 1–16.
•
num_slot is the number of DS0s in the associated DS1. Note that the number of DS0s
cannot be such that the logical port spans more than DS1.
•
port_type is a number representing the mode of operation for the logical port:
1 for Frame Relay; 2 for FUNI mode-1a; and 3 for frame forwarding.
For MGX-FRSM-HS1/B
addport <port_num> <port_type>
•
port_num is the port number in the range 1–4.
•
port_type is a number representing the type of frame interface technology for the
logical port: 1 for Frame Relay; 2 for FUNI mode-1a; or 3 for frame forwarding.
For AX-FRSM-8T1 and AX-FRSM-8E1:
addport <port_num> <line_num> <ds0_speed> <begin_slot> <num_slot>
<port_type>
•
port_num is the logical port number in the range of either 1–192 for T1 or 1–248 for
E1. When you subsequently add a connection through the preferred command addcon
or the addchan command (which requires NSAP format), you must indicate a logical
port by using this singular port_num regardless of the number of DS0s. (You can add
1–24 DS0s to a single line through the other addport parameters.)
•
line_num is the physical line number in the range 1–8.
•
ds0_speed is a number representing the DS0 speed: 1 for 56 Kbps or
2 for 64 Kbps.
•
begin_slot is the beginning DS0 timeslot in 1 base. For example, on port number 50,
you could make begin_slot=9 then specify num_slot to be in the range
1–16.begin_slot is the beginning timeslot in 1 base.
•
num_slot is the consecutive DS0s that each connection on port_num has.
•
port_type is a number representing the mode of operation for the logical port:
1 for Frame Relay; 2 for FUNI mode-1a; and 3 for frame forwarding.
Modify as needed the signaling on a port by executing cnfport.
Step 5
cnfport <port_num> <lmi_sig> <asyn> <elmi> <T391> <T392> <N391> <N392>
<N393>
•
port_num is the logical port number with a range that depends on the type of FRSM:
— For the MGX-FRSM-2CT3, 1–56
— For a channelized AX-FRSM-8T1, 1–192
— For a channelized AX-FRSM-8E1, 1–248
— For the unchannelized cards, the range equals the number of lines.
Configuring the FRSM Cards, Lines, and Ports
Card and Service Configuration 6-29