Cisco MGX-FRSM-2CT3 Configuration Manual page 17

cnfupcubr <port.vpi.vci> <enable> <pcr[0+1]> <cdvt[0+1]> <IngPc> <util> <clp_tag>
port.vpi.vci
enable
pcr
cdvt
scr
scr_police
mbs
IngPc
hclp_tag
If the system has the ForeSight feature, use cnfchanfst to configure it.
Step 3
cnfchanfst <port.vpi.vci> <enable> <fgcra_enable> <ibs> <pcr> <mcr> <icr>
port.vpi.vci
enable
fgcra_enable
ibs
pcr
Adding and Configuring Connections on the AUSM/B
identifies the connection.
is the enabled/disable for UPC: 1=Disable, 2=Enable.
is the peak cell rate. Without IMA, the range is:
T1, 10–3622
E1, 10–4528
clear E1, 10–4830
For IMA, multiply the line rate by the number of links.
cdvt[0+1] is the cell delay variation tolerance for cells with
CLP=[0+1]. The range is 1–250000 micro seconds.
is the peak cell rate. Without IMA, the range is:
T1, 10–3622
E1, 10–4528
clear E1, 10–4830
For IMA, multiply the line rate by the number of links.
specifies the type of scr policing: 1= CLP[0] Cells,
2=CLP[0+1] cells, and 3=no SCR policing.
is the maximum burst size: the range is 1–5000 cells.
is the percent utilization on the ingress. The range is 1–127. The
default is 0.
is the enable for CLP tagging: 1=disable, 2=enable.
identifies the connection.
is the enabled/disable for the ForeSight feature:
1=disable, 2=enable.
is the enabled/disable for the frame-based generic cell rate
algorithm: 1=disable, 2=enable.
is the initial burst size in the range 0–5000 cells.
is the peak cell rate. Without IMA, the range is:
T1, 10–3622
E1, 10–4528
clear E1, 10–4830
For IMA, multiply the line rate by the number of links.
Card and Service Configuration 6-17