Cisco MGX-FRSM-2CT3 Configuration Manual page 16

ATM Universal Service Module
6-16 Cisco MGX 8850 Installation and Configuration, Release 1.1.00, Part Number 78-6186-02
EgSrvRate is the egress service rate. Without IMA, the range is as follows:
T1, 10–3622 cells per second
E1, 10–4528 cells per second
clear E1, 10–4830 cells per second
For IMA, multiply the line rate by the number of links.
EgrPcUtil is the percent utilization on the egress. The range is 1–127.
The default is 0.
cnfupcvbr has the same syntax and parameters as cnfupcabr
cnfupcvbr or cnfupcabr <port.vpi.vci> <enable> <pcr[0+1]> <cdvt[0+1]> <scr>
<scr_police> <mbs> <IngPcUtil> <EgSrvRate> <EgPcUtil> <clp_tag>
port.vpi.vci identifies the connection.
enable is the enabled/disable for UPC: 1=Disable, 2=Enable.
pcr is the peak cell rate. Without IMA, the range is as follows:
T1, 10–3622 cells per second
E1, 10–4528 cells per second
clear E1, 10–4830 cells per second
For IMA, multiply the line rate by the number of links.
cdvt cdvt[0+1] is the cell delay variation tolerance for cells with
CLP=[0+1]. The range is 1–250000 micro seconds.
scr is the peak cell rate. Without IMA, the range is as follows:
T1, 10–3622 cells per second
E1, 10–4528 cells per second
clear E1, 10–4830 cells per second
For IMA, multiply the line rate by the number of links.
scr_police specifies the type of scr policing: 1= CLP[0] cells,
2=CLP[0+1] cells, and 3=no SCR policing.
mbs is the maximum burst size: the range is 1–5000 cells.
IngPcUtil is the percent utilization on the egress. The range is 1–127. The
default is 0.
EgSrvRate is the egress service rate. Without IMA, the range is as follows:
T1, 10–3622
E1, 10–4528
clear E1, 10–4830
For IMA, multiply the line rate by the number of links.
EgrPcUtil is the percent utilization on the ingress. The range is 1–127. The
default is 0.
clp_tag is the enable for CLP tagging: 1=disable, 2=enable.