Table of Contents
Advertisement
Configuring Frame Relay Service
Table 6-2
1–50 Correspond to Line Rates in Kbps.
1=48000
6=168000
11=320000
16=512000
21=1792000
26=3157000
31=6315000
36=9472000
41=12629000
46=15799000
Step 4
6-28
Cisco MGX 8850 Installation and Configuration, Release 1.1.00, Part Number 78-6186-02
Supported Lines rates on the MGX-FRSM-HS1/B
2=56000
3=64000
7=192000
8=224000
12=336000
13=384000
17=768000
18=1024000
22=1920000
23=1984000
27=4096000
28=4645000
32=7744000
33=7899000
37=10240000
38=10890000
42=13897000
43=14222000
47=16384000
48=20025000
The possible errors for cnfln are:
•
One or more parameters are invalid.
•
Line does not exist (has not been added).
•
Loopback or BERT is on.
•
An active port already exists on this line.
If the logical port does not exist or is not the appropriate type (Frame Relay, FUNI, or
frame forwarding), execute addport to create the appropriate type of port. If the logical
port already exists and needs no modification (cnfport), you can add connections by
performing the tasks in "Adding a Frame Relay Connection." The parameters for
addport depend on the type of FRSM:
For MGX-FRSM-2T3, MGX-FRSM-2E3, or MGX-FRSM-HS2/B:
addport <port_num> <line_num> <port_type>
•
port_num is the logical port number in the range 1–2. The mapping between a logical
port and a line is one-to-one for these cards. Note that the maximum committed
information rate (CIR) on each line for these cards is 0-44210000 bps for
MGX-FRSM-2T3, 0-34010000 bps for MGX-FRSM-2E3, and 0-51840000 bps for
MGX-FRSM-HS2. Specify CIR with addcon (or addchan if necessary).
•
line_num is the physical line number in the range 1–2.
•
port_type is a number representing the mode of operation for the logical port:
1 for Frame Relay; 2 for FUNI mode-1a; or 3 for frame forwarding.
For an MGX-FRSM-2CT3:
addport <port_num> <line_num> <ds0_speed> <begin_slot> <num_slot>
<port_type>
•
port_num is the logical port number in the range 1–256. When you subsequently add
a connection through the preferred command addcon or the addchan command
(which requires NSAP format), you must indicate a logical port by using this singular
port_num regardless of the number of DS0s. (You can add 1–24 DS0s to a single
port_num through the other addport parameters.)
4=112000
5=128000
9=256000
10=280000
14=392000
15=448000
19=1536000
20=1544000
24=2048000
25=3097000
29=4736000
30=6195000
34=8192000
35=9289000
39=11059000
40=12390000
44=14336000
45=15488000
49=2498600
50=52000000
Advertisement
Table of Contents
