User Cable Layout - Oki Dr.63514 User Manual

2. User cable layout

The figure below shows the structure of the user cable, which is an accessory for the Dr.63514 in-circuit
emulator. This user cable is used attached to the Dr.63514 in-circuit emulator to connect to the user
application circuit.
60Pin socket
(HRS:HIF3BA-60D-2.54R)
_______________________________________________________________________________________________________________
n Note 1 n
The HIF3BA-60D-2.54R (manufactured by Hirose Electronics, Ltd.) is used as the user
application circuit connector socket for the user cable in the Dr.63514 in-circuit emulator.
Therefore, either the HIF3BA-60PA-2.54DS (right angle pin header type) or the HIF3BA-60PA-
2.54DSA (straight pin header type) from the same manufacturer must be used as the
connector to connect to the user cable in the user application circuit.
_______________________________________________________________________________________________________________________________
3 pin
1 pin
t
2 pin 4 pin
Figure A-2 User cable layout
Side view
polar key side
USR
polar key side
59 pin
polar key side
60 pin
Appendices
A-3