Table of Contents
Advertisement
Chapter 3. Setting Up and Starting Up
1. Setting up and turning on the Dr.63514 in-circuit emulator
This section describes the set up procedure that must be followed prior to turning on the Dr.63514 in-
circuit emulator, and then the procedure for turning on the emulator.
1.1 Device configuration
Before using the emulator for debugging, use the dedicated emulator setup utility to configure it for the
target microcontroller. This utility runs on the development host, transferring device information to the
emulator over a serial cable. The BAUD switches at the rear of the emulator specify the transfer speed.
The emulator stores this configuration data in a built-in EEPROM, so reconfiguration is only necessary
when the target microcontroller changes.
Before using the utility, set the SETICE switch at the rear of the emulator to its ON position, the one for
updating this EEPROM.
SETICE switch
ON
OFF
The ICE setup utility runs on the host computer, transferring device information to the Dr.63514 In-
Circuit Emulator through the RS232C interface. The communication baud rate of the RS232C interface
is set by the dipswitches (BAUD) on the rear panel of the Dr.63514 In-Circuit Emulator unit.
baud rate
4,800bps
9,600bps
19,200bps
38,400bps
51,200bps
57,600bps
76,800bps
115,200bps
The emulator is now ready for the update.
3-2
Device configuration
Debugging (evaluation or emulation)
BAUD
38400
switch
OFF
OFF
OFF
ON
ON
ON
ON
OFF
Operating mode
19200
9600
OFF
OFF
OFF
ON
ON
OFF
OFF
OFF
ON
ON
ON
OFF
OFF
ON
ON
ON
4800
ON
OFF
OFF
OFF
OFF
ON
ON
ON
Advertisement
Table of Contents
