_____________________________________________________________________________________________________
n Note 1 n
Set the emulator switches to the settings in the following table.
Switch label
MODE
VDD.VDDI.SEL
OSC.SEL
XT.SEL
48/64
CMP
BACKUP
_____________________________________________________________________________________________________________________
_____________________________________________________________________________________________________
n Note 2 n
The IBM PC/AT and compatibles do not support the 51,200bps and 76,800bps speeds.
When turning on or resetting the Dr.63514, if an initialization message is not produced on
the dedicated debugger's screen or a communication error occurs, lower both the Dr.63514
baud rate setting and the dedicated debugger's speed parameter.
_____________________________________________________________________________________________________________________
1.2 Switch and Jumper Settings
This section describes the switch and jumper settings needed before starting the emulator.
(1) MODE switch
Set the MODE switch to the desired mode.
Operating mode
Emulation Mode
Evaluation Mode
(2) BAUD switch
Set the BAUD switch to the Host computer baud rate. However, note that this setting is not required if
the emulator is operated in evaluation mode.
Chapter 3. Setting Up and Starting Up
Setting
EMU
IN
IN
IN
option
OFF
ON
MODE Switch
EMU
EVA
3-3