Advertisement
Quick Links
Advertisement
Related Manuals for Winco Care Cliner
Summary of Contents for Winco Care Cliner
- Page 1 OWNER’S OPERATING & MAINTENANCE MANUAL 653 & 654 (XL) Care Cliner 655 & 657 (XL) Drop-Arm Care Cliner 656 Premier Care Cliner 694 Swing-Arm & 695 (XL) Swing-Arm 690 Elite & 691 (XL) Elite Care Cliner Care Cliner PLEASE DO NOT DISCARD THIS MANUAL! KEEP FOR FUTURE REFERENCE AND TRAINING...
-
Page 2: Table Of Contents
4. SAVE ALL BOXES AND PACKING MATERIAL UNTIL AFTER YOU HAVE ASSEMBLED YOUR PRODUCT AND HAVE VERIFIED THAT ALL COMPONENTS ARE FUNCTIONING PROPERLY. Winco assumes no responsibility for damage or injury caused by the improper assembly, installation, use or maintenance of these products. -
Page 3: Important Safety Information
4. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the product to an authorized Winco service center. 5. DO NOT carry or pull this product by power supply cord or use the cord as a handle. - Page 4 No adapter should be used with this product. For an added level of safety; Winco recommends the use of a 120 volt GFCI (ground fault circuit interruptor) outlet.
-
Page 5: Parts List/ Upholstery
902520 35” SEWN WEB BAND (for 695) UPHOLSTERY COLORS ALL UPHOLSTERED PARTS FOR THESE CHAIRS ARE AVAILABLE IN THESE COLORS. PLEASE CONTACT YOUR DEALER OR WINCO FOR COMPLETE PRICING AND DETAILS. MODELS 653-654-655-657 MODELS 656-690-691-694-695 02 ROYAL BLUE 07 GRAY... -
Page 6: Options For Care Cliners
OPTIONS FOR YOUR WINCO CARE CLINER HEADREST COVER: #HC Headrest Cover for 653-655-690-694 Headrest Cover for 654-657-691-695 - Protects the headrest vinyl; Easy installation and removal or replacement. Matches the color of your upholstery. HEAT & MASSAGE: (These options are factory installed ONLY) #H Heat &... -
Page 7: Assembly Instructions
ASSEMBLY INSTRUCTIONS BACK ASSEMBLY INSTRUCTIONS 1. Remove back assembly and chair frame from carton. NOTE: Make sure the footrest is in closed position before installing the back. 2. Lock all casters on chair base. (see Lock/Unlock Casters page 10) 3. Remove the 2 sets of clevis & bow-tie cotter pins located on L&R Forks of Lower Back Frame. DO NOT LOSE THESE PARTS, YOU WILL NEED THEM AGAIN! (FIG. -
Page 8: Parts List/ Specifications
Weight ......111 lbs. Weight ......94 lbs. Maximum Weight Capacity..450 lbs. Maximum Weight Capacity..275 lbs. 657 XL DROP-ARM CARE CLINER 690-691 ELITE CARE CLINER (690 shown) Seat Height ......21” Back Height Above Seat..31.5” Seat Height ......21” Overall Width ..690=34” 691=38"... - Page 9 Back Width ......21” Seat Depth......19.5” Overall Height .....46.5” Weight .......93 lbs. Maximum Weight Capacity..275 lbs. 694-695 SWING-ARM CARE CLINER (694 shown) NOTE: 653-655-656-690-694 Model Chairs have one Gas Spring. 654-657-691-695 (XL) Model Chairs have two Gas Springs. Seat Height ......21”...
-
Page 10: Operating Instructions
OPERATING INSTRUCTIONS RECLINING THE CARE CLINER ALL CHAIRS HAVE 3 STANDARD POSITIONS PLUS INFINITE POSITIONING THRU TRENDELENBERG* WHEN GAS SPRING IS ENGAGED FROM 3rd RECLINE POSITION) 1. From the #1 (SEATED UPRIGHT) position, grip the arm rests and simultaneously lean body weight back. - Page 11 OPERATING INSTRUCTIONS (cont'd) LOCK/ UNLOCK CASTERS (Total-Lock vs. Directional) FIG. 1 1. Total-Lock casters will lock wheel and swivel mechanism by using your foot & pushing down on the tab. Both front and the right-rear casters are Total-Locks. These are identified with lighter gray tabs.
- Page 12 OPERATING INSTRUCTIONS cont'd. SIDE PANEL - REMOVAL / REPLACEMENT (Models 653 / 654 only) 1. For ease of cleaning and chair maintenance; Unscrew two (2) thumbscrews at the front of chair and one (1) thumbscrew at the rear of chair, on inside of each panel. (FIG.
- Page 13 AND connection of power cord to power pack unit under chair. • If switch displays a flashing light; Check all accessible wire connectors under chair for possible loose connections, then contact Winco customer service: 1-800-237-3377. CORD STORAGE (Models with Heat or Massage only) 1.
-
Page 14: General Maintenance
GENERAL MAINTENANCE ADJUSTING GAS SPRING NOTE: Tension or "ease of movement" of the gas spring is set by factory and cannot be changed. The following instruction is for adjusting the gas spring "release and engagement points" for Trendelenburg or "deep recline" positions only. 1. - Page 15 Once per week, position the Chair Back into Please refer to the PERMABLOK full recline position, squeeze release handle instruction tag that is attached to your Care Cliner and go to full Trendelenburg position. This will for complete care and cleaning instructions.
- Page 16 Winco, Inc. shall not be liable for any labor, shipping or any other costs incurred as a result of or in conjunction with a warranty claim.